John at 23:19, 28 September 2015

2015-09-28T23:19:43Z

← Older revision		Revision as of 23:19, 28 September 2015
Line 9:		Line 9:
	#[[Open]]		#[[Open]]
	## Attempt to create a new file when open is for [[Input]] only		## Attempt to create a new file when open is for [[Input]] only
			## ''',Use''' specified on a [[Input]] only open statement.
	#[[Version]]		#[[Version]]
	## Attempt to access version number on file that is not internal or a key file that is opened as internal		## Attempt to access version number on file that is not internal or a key file that is opened as internal
Line 23:		Line 24:
	#Open		#Open
	## If a new file is to be created, OPEN must be for Output or OutIn.		## If a new file is to be created, OPEN must be for Output or OutIn.
			## Remove the ''',Use''' from the syntax.
	#Version		#Version
	## Version may be executed on non-keyed files opened internal only.		## Version may be executed on non-keyed files opened internal only.

Laura: 1 revision

2013-06-28T17:46:50Z

1 revision

New page

{{Error
|0721
|Attempted I/O conflict with [[Open]]
|An I/O conflicts with corresponding open [[statement]]. Some possibilities:
#[[Read]]
## Attempt to read a file that is opened for [[Output]].
## Attempt to read Rec<nowiki>=</nowiki> or Key<nowiki>=</nowiki> to a file opened [[sequential]].
## Attempt to use read on a [[display]] file
#[[Open]]
## Attempt to create a new file when open is for [[Input]] only
#[[Version]]
## Attempt to access version number on file that is not internal or a key file that is opened as internal
## Attempt to reset version number on file that is not opened [[OutIn]]
#[[Write]]/[[Rewrite]]/[[Print]]
## Attempt to ReWrite a record in file that was opened for Output
## Attempt to Write #0
## Attempt to write to a display file
|Change the I/O statement so that it matches the way the file was opened. For the situations noted above:
#Read
## Read may be executed only on files opened for Input or OutIn.
## Read Rec<nowiki>=</nowiki> or Key<nowiki>=</nowiki> may be executed only on files opened relative.
## Use Input or [[LInput]] to read display files.
#Open
## If a new file is to be created, OPEN must be for Output or OutIn.
#Version
## Version may be executed on non-keyed files opened internal only.
## If version number is to be reset, file must be opened OutIn
#Write/Rewrite
## Change Output on the Open Statement to OutIn
## Change the invalid file handle to a valid one
## Change the write to a [[print]]
}}
[[Category:Error Codes]]

0721 - Revision history

John at 23:19, 28 September 2015

Laura: 1 revision