Laura: Created page with "The '''3D_Fields''' BRConfig.sys specification applies to pre 4.0 versions to add a "3d" appearance to the graphical console. The 3D FIELDS parameter UNDR ON ignores al..."

2013-05-07T15:49:24Z

Created page with "The '''3D_Fields''' BRConfig.sys specification applies to pre 4.0 versions to add a "3d" appearance to the graphical console. The 3D FIELDS parameter UNDR ON ignores al..."

New page

The '''3D_Fields''' [[BRConfig.sys]] specification applies to pre 4.0 versions to add a "3d" appearance to the graphical console.

The 3D FIELDS parameter UNDR ON ignores all other attributes for underlined fields. BR used either the N (normal) attribute or R (reverse) attribute and ORed the other attributes specified (H, B, and U), unless UNDR ON is specified and U is present, in which case it uses the U value exclusively. This provides greater control over the color scheme with 3D FIELDS active. You could then use H for other purposes without affecting UH processing.

When 3D fields are enabled, the screen requires more vertical space than it otherwise would. Therefore, the BR window takes on a rectangular appearance, and doesn't look as good in full screen mode as it does as a window.

To activate this feature, specify 3D FIELDS ON in your BRconfig.SYS file and also specify SCREEN U 0170 only. (Or specify SCREEN U 0170,N 38 to add some flair.)

You can also use the CONFIG command to activate this feature, but if so, you
must OPEN #0: "SROW=1,SCOL=1", DISPLAY, OUTIN after executing the CONFIG command.

Specifying 3D FIELDS in BRconfig.SYS is not sufficient to activate it. You must also either precede a standard field attribute with 01 (e.g. U 0170) or specify S as a leading field attribute in your FIELDS specification. For example:

INPUT FIELDS "10,10,C 10,S": X$

The preferred way for legacy code to activate 3D FIELDS is to use the [[SCREEN]] statement. Ctrl-Z will act as undo when DATAHILITE is on.

Note: In very early versions, 3D FIELDS was known as FIELDS3D.

See also [[Datahilite]].

<noinclude>
[[Category:Config]]
[[Category:Needs Help]]
</noinclude>

3D Fields - Revision history

Laura: Created page with "The '''3D_Fields''' BRConfig.sys specification applies to pre 4.0 versions to add a "3d" appearance to the graphical console. The 3D FIELDS parameter UNDR ON ignores al..."